Health Management:
The transfer window is managed at the cleanliness level of the higher-level clean areas associated with it, such as the transfer window between the inkjet and the filling station, which is to be managed in accordance with the requirements of the filling room. After the class by the clean area operator is responsible for the transfer window of the internal surface of the paint wipe clean, and open the UV sterilization lamp for 30 minutes.
Instructions:
(1) materials out of the clean area, must be strictly separated from the flow channel, from the production workshop materials channel access.
(2) materials into the raw materials by the preparation of the class responsible person in charge of the process organization staff or after the appearance of clean-up package, the transfer window to the workshop temporary storage of raw materials; within the package of materials in the temporary storage removed after packaging , Through the transfer window into the internal package. Workshop integrator and preparation, the person in charge of the packaging process for material transfer.
(3) through the transmission window [1] transmission, the transfer window must be strictly implemented inside and outside the door, "a closed" requirement, the two can not open at the same time. Open the door into the material after the first door, and then open the door to the material out, closed, so the cycle.
(4) When the material in the clean area is sent out, the material should be transported to the relevant intermediate station first, and the clean area should be removed according to the reverse procedure when the material enters.
(5) All semi-finished products from the clean area out, are required to be sent from the transfer window to the temporary storage, the logistics channel to transport packaging.
(6) can easily lead to pollution of materials and waste, should be transported from its special window to the non-clean area.
(7) after the end of the material out, should be timely clean-up between the rooms or intermediate stations in the middle of the window and transfer window health, close the transfer window inside and outside the channel door, do a good job cleaning and disinfection.
Precautions:
1. As the transfer window is interlocked, all the doors can not be opened when the side is due to the other side of the door is not closed cause, avoid forced open, otherwise it will damage the interlock device.
2. Material from low to high clean level, should do a good job cleaning the surface of the material.
3. Transfer window interlock device does not work, it should be timely maintenance, or can not be used.
4. Often check the work of the UV lamp, UV lamp replacement on a regular basis.
5. Transfer window can not store any material or debris.